Safety Decals; Orthman Right Side Decals - Orthman 1TRIPR II ROW UNITS Operator's Manual

SAFETY INFORMATION

Safety Decals

Safety decals promote awareness and knowledge
concerning safe operation and maintenance of the
implement. Carefully read all safety decals in this manual
as well as on the implement.
Keep the implement clean so decals are easily visible.
Keep all decals in good, legible condition. Immediately
replace damaged and/or missing decals.

Orthman Right Side Decals

NOTE: Orthman double bar toolbar is shown. Orthman
rigid toolbar is similar.
C A U T I O N
1. Read and understand all operator manuals before implement use.
2. Follow all tractor or towing device operating procedures and safety guidelines.
3. Do not allow riders on implement.
4. Lower implement to the ground, place tractor in park, turn off engine, and remove key.
Wait for all moving parts to come to a complete stop before working on implement.
5. Be extremely careful working around unshielded sharp edges.
6. Make sure all safety lighting and decals are clean. Use hazard lights when in transport.
7. Engage all safety devices before transporting or working beneath implement.
8. Contact or close proximity to power lines can result in electrocution.
9. Review all safety instructions with all operators on a frequent basis.
See the Orthman toolbar operator manual for proper
placement of safety decals.
NOTE: Replacement decals are available from your
Orthman dealer. When replacing decals,
thoroughly clean the area where the decal is to be
placed and attach the decal void of bubbles.
Figure 2-5
2-10
ORM000250
1TRIPR II Row Units OM-EN