Table of Contents
Advertisement
3.2 Connecting the EzScan
To install and connect the EzScan Scanner:
STEP 1.
Place the docking base on a flat, stable surface and
place the EzScan handpiece securely on the base.
STEP 2.
Connect the AC/DC power adapter cable to the docking
base (the connector socket is located underneath the
base of the scanner).
WARNING: Make sure you use the 5.0V 4A power adapter
provided. Failure to do so may result in damage to the scanning
device.
STEP 3.
Connect the provided USB 3.0 cable to the docking
base (the connector socket is located underneath the
base of the scanner).
WARNING: Using a USB cable other than the one provided may
result in system malfunction or reduced performance.
STEP 4.
Connect the other end of the USB 3.0 cable to the
computer.
Page 15
Advertisement
Table of Contents
Need help?
Do you have a question about the EzScan-i and is the answer not in the manual?