Table of Contents
Advertisement
STEP 14.
You
Alignment based on the chosen
paired-points:
C. Scan a
molar/pre-molar
When you have finished manually aligning one side
of the bite, you will be prompted to scan the
opposing side.
Carry out the same procedure as described above in
steps 2-14.
STEP 15.
Scan a 2-3 teeth and 7-8mm gum segment
on the RIGHT molar/pre-molar region in
Occlusion...
NOTE: While it is recommended, when carrying out full-arch scans, to scan both left
and right bite segments, it is possible to carry out bite alignment by scanning a
single bite segment.
See above:
Bite-alignment using a single bite segment
7.17
Auto-Realignment
The Auto-Realignment feature enables you to optimize the scans of the maxillary
and mandibular arches. The EzScan-i software's AI will recalculate the results using
specially developed imaging algorithms, retaining only the most accurate frames for
3D image reconstruction.
STEP 1. In the Tools menu, click on the Auto-
Realignment icon. You will be prompted
to confirm the optimization.
STEP 2. Click OK to start Auto-Realignment
optimization of the scans.
NOTE: Auto-Realignment may take a couple of minutes.
will be invited to start the Bite
click Start.
bite segment on the opposing side
Page 63
Advertisement
Table of Contents
Need help?
Do you have a question about the EzScan-i and is the answer not in the manual?