Advertisement
Easy to set up
Maestro Wireless products can be set up quickly and easily.
Step 1
Press and hold the dimmer or switch
tap button for approximately six seconds.
Once the LED(s) starts to blink slowly,
release the tap button.
Step 2
Press and hold the "off" button on the Pico
wireless control or
TM
sensor for approximately six seconds. When the dimmer or switch
learns the Pico wireless control or sensor, its LED and load will
flash three times and the device will exit setup mode.
Repeat steps 1 and 2 to set up multiple Pico wireless controls or sensors to a single dimmer.
Repeat steps 1 and 2 to set up a single Pico wireless control or sensor to multiple dimmers.
Easy to use
The Pico
wireless control and Maestro Wireless dimmer are easy for any
TM
homeowner to use.
turn dimmer(s) on to
100% brightness
raise lights
turn dimmer(s) on to
your favorite light level
lower lights
turn dimmer(s) off
LEDs indicate light level and glow softly so
you can find the dimmer in the dark
rocker adjusts light level to suit any activity
tap once to turn lights on to favorite level,
tap twice for full on, press and hold for
delayed fade-to-off
Advertisement
