Assigning The Ip Address: Serial Port Login - Lantronix UDS 1100 User Manual




Assigning the IP Address: Serial Port Login

To assign the IP address and other network settings using a serial
connection:
Connect a console terminal or a PC running a terminal emulation program to
1.
the unit's serial port. The default serial port settings are 9600 baud, 8 bits,
no parity, 1 stop bit, no flow control.
To enter Setup Mode, cycle the unit's power (power off and back on). After
2.
power-up, the self-test begins and the red Diagnostic LED starts blinking.
You have one second to enter three lowercase x characters.
Note:
at the terminal (or emulation) while powering up the unit.
Select 0 (Server Configuration) and follow the prompts until you get to
3.
IP address.
Enter the new IP address, subnet mask, and gateway (if applicable).
4.
Do one of the following:
5.


UDS1100 Device Server User Guide
To configure the unit using a Web browser, click the Web Configuration tab.
The Lantronix Web-Manager window displays in your browser. Continue with
5: Configuration Using Web-Manager.
Note: To assign Expert and Security settings, you must use the
Setup Mode window in a Telnet session.
To configure the unit using a Telnet session, click the Telnet Configuration tab.
The Setup Mode window displays. Continue with
Serial Port (Setup Mode).
The easiest way to enter Setup Mode is to hold down the x key
Continue with 5: Configuration via Telnet or Serial Port (Setup Mode).
Select 9 to save and exit Setup Mode. The unit performs a power reset.
4: Using DeviceInstaller
6: Configuration via Telnet or
22