5.4.1.3
Installing a SCSI Extender Cable
If you are installing an LSI MegaRAID card, you must install the SCSI extender cable
that is shipped with the card:
1. If you have not already done so, remove the power-supply cage assembly: see
"Replacing a Power-Supply Cage Assembly" on page 5-30.
2. Disconnect the server's SCSI signal cable from the motherboard.
See
FIGURE 5-9
SCSI signal cable
motherboard connector
location under power-supply cage
FIGURE 5-9
3. Plug the end of the extender cable that is labeled "SCSI Cable" into the SCSI
signal cable that you disconnected from the motherboard.
4. Plug the other end of the extender cable (labeled "SCSI CNTRLR Board") into the
LSI MegaRAID card connector. Lay the extender cable over any existing cards.
5. Reinstall the power-supply cage assembly: see "Replacing a Power-Supply Cage
Assembly" on page 5-30.
for the location of the SCSI signal cable motherboard connector.
SCSI signal cable
SCSI Signal Cable
Chapter 5 Maintaining the Sun Fire V40z Server
5-13