Scsi Backplane - Sun Microsystems Sun Fire V20z User Manual

4.5.4

SCSI Backplane

The following procedure describes how to replace the SCSI backplane.
1. Power off the system and remove the cover as described in "Powering Off the
Server and Removing the Cover" on page 4-2.
2. Remove all hard disk drive (HDD) carriers:
a. Squeeze the release latch and swing the arm to the left as far as it will go.
b. Grasp the carrier bezel with both hands and carefully pull the carrier out of the
drive bay (see
Note – Avoid using the arm to remove the carrier.
FIGURE 4-7
3. Remove screw that holds the center air baffle and remove the baffle from the
server (see
4-16 Sun Fire V20z and Sun Fire V40z Servers User Guide • December 2004
).
FIGURE 4-7
SCSI HDD Carrier and Release Latch
).
FIGURE 4-8