V1100Pro Software Interface Introduction - Walkera V1100 PRO Quick Start Manual

V1100 PRO
Quick Start Guide

7.0 V1100Pro Software Interface Introduction

In this interface, you can preview the live HD video and photos taken by V1100 PRO, and dynamically set the
parameters of the aircraft, remote control, gimbal and battery.
1
Connected
25
26
24
23
22
21
D
15 m
20
1) Back: Back to previous page.
2) Device connection status: Display Aircraft connected or
disconnected.
3) Flight time: Aircraft flight time.
4) Aircraft mode: Display aircraft's flight mode.
5) Aircraft satellites: Display the number of satellites received
by the aircraft.
6) Positioning accuracy: Display positioning accuracy of the aircraft.
7) HD image transmission signal strength: Display the strength
of the video signal transmitted between the aircraft and the
remote control.
8) Remote signal strength: Display the control signal strength
between the remote control and the aircraft.
9) Remote control battery level: Display the current remaining
battery of the remote control in real time.
10) Aircraft battery voltage: Display the current battery voltage
of the aircraft in real time.
11) Settings: Tap the icon "
General, aircraft, remote control, gimbal and battery can be set.
12) Camera settings: Tap the icon "
and Other settings. For videos with the same resolution,
the higher the bit rate, the better the image quality, and the
image transmission distance will be shortened accordingly.
Others: (1) Grid; (2) Anti-flicker; (3) Defog;
(4) 2.4G & 5.8G Switch; (5) Navigator.
12
2 3
03:58:45
GPS
14
15
3 m
4
5
H H.S
17.1 m 0.0 m/s
19
" to open the Settings menu, where
" for Pro, Photo, Video
4 5 6
AUTO Mode
18
N/A
V.S P R
0.0 m/s 0.0° 0.0°
Subject to the interface of the actual product
Fig.7.0-1
13) Camera working mode switch: Each time the icon " Camera working mode switch: Each time the icon "
tapped, the camera will switch once between Photo and
Video modes.
When switching to Photo mode: tap the icon "
the camera to take photos.
When switching to Video mode: tap the icon "
/stop recording.
14) Camera zoom control: divided into Wide-angle (W) and
Telescope (T).
15) PTZ quick actions: Back to center and down.
16) Latitude & Longitude: Display the longitude and latitude
of the aircraft's position.
17) GPS positioning status: "GPS Positioning" is shown when
GPS signal connected; "GPS Not Positioning" is shown
when GPS signal not connected.
18) Volume adjustment: Tap the icon to show the volume
adjustment switch of the tone.
19) Remote control system navigation icons:
" " Back: Tap the icon to go back to the previous page;
" " Return to Home Screen: Tap the icon to return to the
" " Task Management: Tap the icon to display all currently
20) Screen Capture: Tap the icon to capture and save an
image of the entire screen currently being displayed.
7 8 9 10
2.4G
51.98V
98%
T
2X
W
Center
GPS Ready
Y
0.0°
system home screen;
running tasks;
Walkera All Rights Reserved
11
12
13
14
15
Down
16
17
18
" is " is
MODE
" to trigger
" to start