Tx5834(Fcc)/Tx5835(Ce) Video Transmitting Channel Selection; Osd Interface Information Introduction - Walkera Runner 250 PRO Quick Start Manual

11.2 TX5834(FCC)/TX5835(CE) Video transmitting channel selection

Port introducton
1. Position of 5.8G antenna
2. Transmitter code switch
3. OSD code switch
Video transmitting channel selection
There are 8 channels avilable, chose the best channel based on the image quality on your screen.
Select the channel by adjusting the dip-switches on the video-transmitter according to the diagram.
1
Channel
5866MHz(CE)
Frequency
5847MHz(FCC)
Code
position
(on/off)
Attention:
Video transmitter channel must match the reciever channel.

11.3 OSD interface information Introduction

The OSD information is visible on your video reciever.
* Goggles or screen with video reciever.
Front
Angle
Home point
Attention:
When the arrow points straight down,
pull back the ELEV stick, then the drone will fly back to Home position.
OSD code switch from "1" to "ON" to start the OSD.
Quick Start Guide
2 3
5847M Hz 5 828M Hz
Arrow direction indicating the angle
between the aircraft's tail and
Home points
Number of satellites
ascend/descend
speed
Horizontal
flight speed
The aircraft battery volume
4 5
580 9 MHz 57 90 MHz
200°
10
M
1.5
S
M
20
h
12.6V R 15°
ROLL
-15-
6 7
5 77 1 MHz 57 5 2MHz
The yaw angle
Horizontal distance
Remote Controller
30M
battery volume
Flight height
10M
Timer
10:00
P 15°
PITCH
8
5 73 3MHz