Walkera V1100 PRO Quick Start Manual page 18

V1100 PRO
Quick Start Guide
GPS Mode
Turn the flight mode switch to the "GPS" position and push the throttle stick back to center. Then, the aircraft will enter the GPS mode.
Attentions:
1)The first flight of the aircraft defaults to GPS Mode after each power on.
2) In GPS mode, altitude holding, location fixing and braking functions are available, and the flight speed is lower.
3) If the GPS signal is poor or there is no signal, it can only set the altitude, but not the location.
4) After switching to manual mode, location fixing is invalid.
Waypoint mode
Turn the flight mode switch to the "Waypoint" position, and the aircraft will enter the waypoint flight mode.
Route flight (operate in APP map interface)
Tap the icon in the map interface to enter the route flight
interface.
Clear Click this icon to clear waypoints
Add Click this icon to add waypoints
Start Click this icon to start waypoints flight
Exit Click this icon to exit
Y ou can only enter the route flight and route planning interfaces when the aircraft is in GPS mode.
18
Waypoint
GPS
Manual
Fig.11.0-7
Waypoint
GPS
Manual
Fig.11.0-8
Route planning (operate in APP map interface)
Tap the icon Tap the icon
interface.
Set fore-
and-aft
course
overlap
in the map interface to enter the route planning in the map interface to enter the route planning
CLEAR
Angle:
Angle:
GENERATE
H: Set waypoint
LINE
height
30
H
ALIGN
EDGE
4
W
START
W: Set sidelap
EX IT
Walkera All Rights Reserved
Click this icon to clear waypoints
Firstly, set the waypoint on the
map interface and touch this
icon to generate the route.
Touch this icon to align the edges
after the route is generated.
Touch this icon to start flying.
Click this icon to exit