Walkera V1100 PRO Quick Start Manual page 17

Walkera All Rights Reserved
Manual takeoff
Operate the sticks as shown in Figure 11.0-1 to start the motor, then push the throttle stick up to allow the aircraft to take off.
Left and right sticks (to start the motor)
Auto Takeoff
After the motor is unlocked, in the GPS mode, short press the D button of the automatic take-off and landing button and the aircraft
will take off automatically and hover 3 meters above the ground.
Fig.11.0-3
Left and right sticks (to start the motor)
Attentions:
1) Auto Takeoff can work only in GPS mode.
2) The default altitude of Auto Takeoff is 3m. When you need to control the throttle manually, you must push the throttle stick to the
middle point or over to release the Auto Takeoff mode.
3) After auto takeoff, please switch to the remote control flight mode according to your needs.
Manual Landing
Pull down on the throttle stick until the aircraft lands on the ground. When the aircraft is landed, push the throttle stick down to the
lowest position and hold it for 5 seconds. The motors will then stop.
Auto Landing
Flight mode switch In GPS mode, short press the automatic take-off and landing button D key, the aircraft will land automatically.
After landing on the ground, the motor will automatically stop.
Attentions:
1) During landing, you can operate the aircraft forward and backward/left and right.
2) If you need to cancel the landing during the landing, short press the D key again to cancel the landing.
Fig.11.0-1
Waypoint
GPS
Manual
In the GPS mode
Fig.11.0-2
Throttle stick (left stick for American hand mode)
Waypoint
GPS
Manual
Fig.11.0-4
In the GPS mode
Throttle Stick
Fig.11.0-5
RTH
Power
Fig.11.0-6
Press the D button
V1100 PRO
RTH
Power
Press the D button
Quick Start Guide
17