Remote Control Stick Mode Switch And Stick Calibration - Walkera V1100 PRO Quick Start Manual

V1100 PRO
Quick Start Guide

15.2 Remote control stick mode switch and stick calibration

The remote control stick mode and stick calibration have been set at the factory.
Please refer to the following method for mode switching and calibration;
Be sure to power off the aircraft or lock the motor before operation.
Stick mode switch
1) Tap the " " icon in the APP interface, and then tap"
icon enter the remote control settings interface.
Stick and Gimbal thumbwheel calibration:
Press and hold the "
Spray
stick/thumbwheel several times within mechanical tuning range (Max. to Min.) and then return to center.
Press and hold the "
Spray
If a vibration alert sounds when exiting, the calibration failed, please recalibrate.
22
" button for 3~ 5 seconds to go to stick calibration while four indicators are flashing alternately. Operate the
" button again for 3~ 5 seconds. When the four indicators are steady on, confirm and exit stick calibration.
" 2) Tap "Stick Mode" to enter the stick mode selection interface,
and select the mode you want.
Walkera All Rights Reserved