Table of Contents
Advertisement
Walkera All Rights Reserved
10.0 Prepare for Flight
Before fly the aircraft, please cache the map (turn off the aircraft and tap the "Map Thumbnail" as
connected to the Internet to cache the map). Please place the aircraft in an open outdoor area with
the operator facing the tail of the aircraft.
10.1 Activate the aircraft
1
Open the battery compartment door to
load two batteries and connect the two
batteries in series.
Make sure to use two identical batteries to power the aircraft.
Before installing the batteries, ensure that the batteries is fully charged.
Connect the aircraft power: first connect the negative pole (the black wire connects to the black wire),
and then connect the positive pole (the red wire connects to the red wire).
Power off the aircraft: first disconnect the positive pole (red wire) and then the negative pole (black wire).
It is forbidden to short-circuit the positive and negative terminals of the battery.
10.2 Get binding of your aircraft
Place the aircraft in a horizontal position, and the indicator light of
the aircraft will change from fast flashing to slow flashing to indicate
successful code matching. (Check connection status with APP)
10.3 Run V1100Pro software
1)Tap the "V1100Pro" icon
on the touch screen.
2
Turn on the remote control.
2)Tap "Select Device", select "V1100Pro-30 Zoom"
and tap "Go to Connect".
V1100 PRO
3 3
Connect the battery power cord to the
aircraft power cord (red to red, black to
black), then close and lock the battery
compartment door.
Fig.10.2
Connected
03:58:45
AUTO Mode
GPS
N / A
Warning
Make sure the GPS antenna
position is correct first!
14
15
Confirm
3 m
4
5
D
H
H.S
V.S
P
15 m
17.1 m
0.0 m/s
0.0 m/s
0.0°
3)After entering the main interface, first check
the aircraft to confirm that the GPS antenna
has been turned on, and then click "Confirm"
Quick Start Guide
2.4G
51.98V
18
98%
T
2 X
W
Center
Down
GPS Ready
R
Y
0.0°
0.0°
15
- Quick Links:
- Specifications
Hide quick links:
Advertisement
Table of Contents
