Tx5834(Fcc)/Tx5835(Ce) Video Transmitting Channel Selection; Osd Interface Information Introduction - Walkera RUNNER 250 PRO Quick Start Manual

11.2 TX5834(FCC)/TX5835(CE) Video transmitting channel selection
Port introducton
1. Position of 5.8G antenna
2. Transmitter code switch
3. OSD code switch
Video transmitting channel selection
There are 8 channels avilable, chose the best channel based on the image quality on your screen.
Select the channel by adjusting the dip-switches on the video-transmitter according to the diagram.
Channel 1 2 3 4
5 6
7 8
Frequency
5866MHz(CE)
5847MHz 5828MHz 5809MHz 5790MHz 5771MHz 5752MHz 5733MHz
5847MHz(FCC)
Code
position
(on/off)
ON
1 1
1 2 3
ON
lil I!
15
1 2 3
ON
11 il 1
1 2 3
ON
lil lil 15
1 2 3
ON
15 51 lil
1 2 3
ON
lil 15 lil
1 2 3
ON
51 il il
1 2 3
ON
il il li
1 2 3
Q
Attention:
• Video transmitter channel must match the reciever channel.
11.3 OSD interface information Introduction
The OSD information is visible on your video reciever.
* Goggles or screen with video reciever.
Arrow direction indicating the angle
between the aircraft's tail and
Home points
The yaw angle
Number of satellite
Horizontal distance
0
t
10
.c.1.5"4
-T-
$200°
1
30M
ascend/descend
speed
-1- -
Horizontal
flight speed
Item
The aircraft battery volume
12.6V
LJ
R 15° P 15° 010:00
Attention:
ROLL PITCH
^ Remote Controller
battery volume
Flight height
Timer
• When the arrow points straight down,
pull back the ELEV stick, then the drone will fly back to Home position.
• OSD code switch from "1" to "ON" to start the OSD.
-15-