Check Battery Level; Charge - Walkera V1100 PRO Quick Start Manual

V1100 PRO
Quick Start Guide

5.0 Check Battery Level

※ Please turn on the remote controller to check the battery level. Be sure to fully charge the battery for the first time of use.
Method:
Press and hold the ON/OFF button on the remote control for 2~ 3 seconds to turn on the remote control.

6.0 Charge

6.1 Charge the remote control
Note: The input power of the DC15V 4A power adapter is 100~240V 50/60HZ AC.
There are two ways to charge the remote control battery
rechargeable battery:
Method one:
Without removing the battery, use a DC15V 4A power adapter
to directly connect to the charging port of the remote control
for charging.
1) Please charge with the remote control turned off.
2) The green light on the remote control charging complete indicator
is on --- it means it is fully charged.
Method two:
Charge with GA008 charger.
1) To charge with the GA008 charger, the battery must be removed from the remote control, as shown in Figure 6.0-2.
2) Connect the remote controller battery, GA008 charger, 15V 4A power adapter to charge as shown in Figure 6.0-3.
3) The GA008 charger indicates that the red light is always on --- means charging, and the green light is on --- means it is fully charged.
Press the buttons on both sides
and remove the battery upward
Fig. 6.1-2
Tips:
Pls. remove battery from the remote control and charge the battery by GA008 charger
in order to shorten the charging time of the battery.
10
Low High
Level
Fig. 5.0
Finished charge
green indicator
Fig. 6.1-3
Walkera All Rights Reserved
Charging port
Fig. 6.1-1
Charging Red
indicator