6
Install internal components
Power amplifier (2x500W) PV2002-A1
6.7.4 Connect 100 V analog audio output
78 | 173
Pin
Description
9
CH B OK
10
CH B OK
11
230 V OK
12
230 V OK
Table 35: PV2002-A1 analog audio input and control connector - 'CH B'
WARNING
Voltages of up to AC 100 V at the 100 V analog audio output terminals
Contact with live parts can lead to electric shock and may be fatal!
●
Disconnect AC 230 V mains voltage before performing any installation or
maintenance work.
●
Disconnect DC 24 V power supply voltage before performing any installation
or maintenance work.
●
Ensure that the power supply cannot be re-energized inadvertently.
The 'Power amplifier (2x500W)' PV2002-A1 provides two connectors ('Out A' and
'Out B') to connect the 100 V analog audio outputs.
1
1
Out B
Out A
Fig. 56: PV2002-A1 100 V analog audio output connectors
100 V analog audio output connectors - 'Out A' and 'Out B'
Pin
Description
1
0 V
2
50 V
3
100 V
Table 36: PV2002-A1 100 V analog audio output connectors - 'Out A' and 'Out B'
The outputs are connected to the 100 V analog audio inputs of the digital audio
matrix PC200x-A1. The digital audio matrices supervise the amplifiers and the
speaker lines.
The output voltage can be selected between 100 V and 50 V.
It is prohibited to use the outputs in the bridged mode.
Remark
Relay output channel B ok, open: fault
Relay output channel B ok, open: fault
Relay output 230 V ok, open: fault
Relay output 230 V ok, open: fault
Remark
0 V reference
50 V output
100 V output
A6V10430579_en--_b