5.1.9.
Setup Page 9: Enable/ Disable Stability Indicator
This setup option allows you to set the stability indicator to be
displayed on the screen whenever reading has stabilized, thus
minimizes guesswork.
To Set Stability Indicator
1. Access the Set Stability Indicator setup page by pressing the
setup key while in measurement mode till the page displays as
shown below.
2. Press enter to accept (ON) to enable stability indicator and return
to measurement screen
OR
Press setup to go to Disable Stability Indicator (OFF) setup page
as shown on the following page.
3. Press enter key to confirm selection and return to measurement
mode
OR
Press setup again to go to next setup option without making any
changes.
press
setup
to select options
press
enter
to accept
ST AB L E
22