Setup Page 7: Enable/ Disable Auto Cal - Fisher Scientific accumet AB40 User Manual

5.1.7.

Setup Page 7: Enable/ Disable Auto Cal

This setup option allows you to enable the auto calibration for % Sat
and mg/L modes.
To Enable/ Disable Auto Cal
1. Access the Auto Cal setup page by pressing the setup key while
in measurement mode till the page displays as shown in the
following page.
2. Press enter to accept (YES) to enable auto calibration and return
to measurement screen
OR
Press setup to go to Disable Auto Cal Page (NO).
3. Press enter key to confirm selection
OR
Press setup again to go to next setup option without making any
changes.
19