Fisher Scientific accumet AB40 User Manual page 13

2. If the unit has not been standardized, a series of dashes will
appear on the display rather than a number.
3. Press enter to return to measurement mode
OR
4. Press setup to go to the next setup option without making any
changes.
If you access this setup page from %Sat mode and if you have
calibrated one point (100% Sat) then you can view the last calibration
factor. Should you have calibrated 2 points (100%Sat and 0%Sat),
you will be able to view both the last calibration factor and 0% offset.
If you access the setup page from mg/L mode, and if you have
calibrated mg/L, you will be able to view the last calibrated value in
mg/L.
11