Removing The Clutch; Checking The Friction Plates - Beta RR 125 LC Manual

EAS25070

REMOVING THE CLUTCH

1. Remove:
• Clutch cover
TIP
Loosen each bolt 1/4 of a turn at a time, in stag-
es and in a crisscross pattern. After all of the
bolts are fully loosened, remove them.
2. Straighten the lock washer tab.
3. Loosen:
• Clutch boss nut "1"
TIP
While holding the clutch boss "2" with the univer-
sal clutch holder "3", loosen the clutch boss nut.
3
EAS25100

CHECKING THE FRICTION PLATES

The following procedure applies to all of the fric-
tion plates.
1. Check:
• Friction plate
Damage/wear → Replace the friction plates
as a set.
2. Measure:
• Friction plate thickness
Out of specification → Replace the friction
plates as a set.
TIP
Measure the friction plate at four places.
A
1
2
C
A. Friction plate 1
B. Friction plate 2
C. Friction plate 3
a. Green paint mark
Friction plate 1 thickness
2.90–3.10 mm (0.114–0.122 in)
Wear limit
2.80 mm (0.110 in)
Friction plate 2 thickness
2.90–3.10 mm (0.114–0.122 in)
Wear limit
2.80 mm (0.1102 in)
Friction plate 3 thickness
2.90–3.10 mm (0.114–0.122 in)
Wear limit
2.80 mm (0.1102 in)
B
CLUTCH
a