Beta RR 125 LC Manual page 24

5. Turn:
• Crankshaft
(several turns counterclockwise)
6. Check:
• "I" mark "a"
Align the "I" mark on the generator rotor with
the stationary pointer "b" on the generator
cover.
• "I" mark "c"
Align the "I" mark on the camshaft sprocket
with the stationary pointer "d" on the cylinder
head.
Out of alignment → Correct.
Refer to the installation steps above.
d
c
7. Tighten:
• Camshaft sprocket bolt
Camshaft sprocket bolt
30 Nm (3.0 m·kgf, 22 ft·lbf)
ECA22B1010
NOTICE
Be sure to tighten the camshaft sprocket bolt
to the specified torque to avoid the possibil-
ity of the bolt coming loose and damaging
the engine.
8. Measure:
9. Valve clearance
Out of specification → Adjust.
b
a
CYLINDER HEAD