Checking The Engine Oil Level; Changing The Engine Oil - Beta RR 125 LC Manual

8. Install:
• Spark plug
Spark plug
13 Nm (1.3 m·kgf, 9.4 ft·lbf)
9. Connect:
• Spark plug cap
EAS28920

CHECKING THE ENGINE OIL LEVEL

1. Stand the vehicle on a level surface.
TIP
• Place the vehicle on a suitable stand.
• Make sure the vehicle is upright.
2. Start the engine, warm it up for several min-
utes, and then turn it off.
3. Check:
• Engine oil level
The engine oil level should be between the
minimum level mark "a" and maximum level
mark "b".
Below the minimum level mark → Add the
recommended engine oil to the proper level.
TIP
• Before checking the engine oil level, wait a few
minutes until the oil has settled.
• Do not screw the engine oil filler cap (dipstick)
"1" in when checking the oil level.
1
Type
SAE 10W-30, SAE 10W-40, SAE
15W-40, SAE 20W-40 or SAE
20W-50
Recommended engine oil grade
API service SG type or higher,
JASO standard MA
-20 -10
ECA22B1020
NOTICE
• Engine oil also lubricates the clutch and the
wrong oil types or additives could cause
clutch slippage. Therefore, do not add any
chemical additives or use engine oils with a
grade of "CD" "c" or higher and do not use
oils labeled "ENERGY CONSERVING II"
"d".
• Do not allow foreign materials to enter the
crankcase.
1
4. Start the engine, warm it up for several min-
utes, and then turn it off.
5. Check the engine oil level again.
TIP
Before checking the engine oil level, wait a few
minutes until the oil has settled.
b
a
EAS20810

CHANGING THE ENGINE OIL

1. Start the engine, warm it up for several min-
utes, and then turn it off.
2. Place a container under the engine oil drain
plug.
3. Remove:
• Engine oil filler cap (dipstick) "1"
• Engine oil drain plug "2"
• O-ring "3"
• Spring "4"
• Engine oil strainer "5"
0 10 20 30 40 50 ˚C
SAE 10W-30
SAE 10W-40
SAE 10W-50
SAE 15W-40
SAE 20W-40
SAE 20W-50
ENGINE