Beta RR 125 LC Manual page 16

5
4
3
2
4. Drain:
• Engine oil
(completely from the crankcase)
5. If the oil filter element is also to be replaced,
perform the following procedure.
M MMM M MMM M M MMM M
a. Remove the oil filter element cover "1" and oil
filter element "2".
b. Install a new O-ring "3".
1
c. Install the new oil filter element and the oil fil-
ter element cover.
Oil filter element cover bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
L LLL L LLL L L LLL L
6. Check:
• Engine oil strainer
Dirt → Clean.
7. Install:
• Engine oil strainer
• Spring
1
2
M MMM M M MMM M M MMM M
2
3 New
L LLL L L LLL L L LLL L
• O-ring
• Engine oil drain plug
8. Fill:
• Crankcase
(with the specified amount of the recom-
mended engine oil)
Engine oil quantity
9. Install:
• Engine oil filler cap (dipstick)
10.Start the engine, warm it up for several min-
utes, and then turn it off.
11.Check:
• Engine
MMM
(for engine oil leaks)
12.Check:
• Engine oil level
13.Check:
• Engine oil pressure
M MMM M MMM M
a. Slightly loosen the oil check bolt "1".
b. Start the engine and keep it idling until engine
LLL
oil starts to seep from the oil check bolt. If no
engine oil comes out after one minute, turn
the engine off so that it will not seize.
c. Check the engine oil passages, the oil filter
element and the oil pump for damage or leak-
age.
New
Engine oil drain plug
32 Nm (3.2 m·kgf, 23 ft·lbf)
Total amount
1.15 L (1.22 US qt, 1.01 Imp.qt)
Without oil filter element replace-
ment
0.95 L (1.00 US qt, 0.84 Imp.qt)
With oil filter element replace-
ment
1.00 L (1.06 US qt, 0.88 Imp.qt)
M MMM M M MMM M M MMM M
ENGINE
M MMM M MMM
1