LifeFitness CLUB Series Assembly Instructions Manual page 15

FIGURE 13
STEP 13:
• Carefully route the CABLE around the pulleys as shown. Make sure the CABLE is in the grooves of all the pulleys.
• SECURELY assemble the 4-1/2" PULLEY (31) to the horizontal pulley bracket on the SEAT FRAME (9) using one RH CAP (28),
one 3/8 X 1-3/4" BOLTS (13), one 3/8" RH WASHER (22), one CABLE CLIP (33), and one 3/8" LOW HEIGHT LOCK NUT
(19).as shown in FIGURE 13.(Note position of CABLE CLIP (33)
FIGURE 14
STEP 14:
• SECURELY assemble one 3/8 X 2-1/2" BOLT (14), two RH CAPS (28), two 3/8" RH WASHERS (22), two 3/8" SAE WASHERS
(21) and one 3/8" LOW HEIGHT LOCK NUT (19) to the SEAT FRAME (9) as shown in FIGURE 14. (NOTE: Make sure
CABLE runs over the retaining bolt.)
• SECURELY assemble the swivel end of the CABLE to the PIVOT ARM (7) using one 3/8 X 3" BOLT (16), two RH CAPS (28), two
3/8" RH WASHERS (22), two 3/8" SAE WASHERS (21), two 1/2" SPACERS (32) and one 3/8" LOW HEIGHT LOCK NUT (19).
(NOTE: SECURELY tighten, then back nut off 1/4 turn)
• REFER TO SHROUD KIT ASSEMBLY INSTRUCTIONS.
1/2
0
7
16 3/8 X3"
28
14 3/8 X 2-1/2"
1/2 1/2
1 2
22
9
32
CABLE
22
21
9
1/2
3 4
15
28
13 3/8 X 1-3/4"
31
33
19
19
1/2 1/2
5
6