Download
Share
Print this page
LifeFitness Club Series Assembly Instructions Manual
  1. Manuals
  2. Brands
  3. LifeFitness Manuals
  4. Elliptical Trainer
  5. Club Series
  6. Assembly instructions manual
LifeFitness Club Series Assembly Instructions Manual

LifeFitness Club Series Assembly Instructions Manual

Hide thumbs Also See for Club Series:
1
2
3
4
5
6
7
8

Advertisement

Quick Links

Download this manual See also: Operating Manual
Club Series Cross-Trainer
Assembly Instructions

Advertisement

loading

Related Manuals for LifeFitness Club Series

Summary of Contents for LifeFitness Club Series

  • Page 1 Club Series Cross-Trainer Assembly Instructions...
  • Page 2 Congratulations... and welcome to the world of and the Life Fitness Club Series Cross-Trainers. The following Parts List and the step by step assembly procedures have been assem- bled to make the set-up of the Cross-Trainer as quick and easy as possible.

  • Page 3: Safety Instructions

    MPORTANT AFETY NSTRUCTIONS DO NOT locate the Cross-Trainer outdoors, near swimming pools, or in areas of high humidity. DO NOT operate your Cross-Trainer if it has been dropped, damaged, or even partially immersed in water. If this occurs, contact Life Fitness Customer Support Services at the num- ber in the Operation Manual.

  • Page 4: Parts List

    TOOLS REQUIRED FOR ASSEMBLY... Magnetic #2 Bit Phillips Screwdriver, 5/16" & 3/16" Hex Key Wrenches, 1/2" Open End Wrench PARTS LIST Qty: 8 Qty: 8 Hex socket Head Cap Screw Phillips Pan Head Screw 3/8-16 x 1” #8-18 x 10” 0017-00101-1645 0017-00101-1744 Qty: 14...
  • Page 5 Step 1 Before proceeding, familiarize yourself with the parts of the Cross-Trainer and make sure that you have received all the items described in the Parts List. Step 2 Locate the left and right FRONT COVER (#9, #10). Using two PHILLIPS PAN HEAD SCREWS (#3), mount the USER LEFT FRONT COVER (#9) to the FRAME (A).
  • Page 6 Step 4 Detach and unwrap the WIRE HARNESS (E) (10P, 3P, 4P) located at the top of the MONOCOLUMN (F). Holding the CONSOLE SUPPORT ASSEMBLY (#7) with the handgrips facing upward, feed the WIRE HARNESS up through the neck and out the top access hole. Carefully lower the CON- SOLE SUPPORT ASSEMBLY into the MONOCOLUMN.
  • Page 7 Step 10 Locate the POLAR RECEIVER (#16). Slide the FOAM ISO- LATOR #15) over the POLAR RECEIVER. Remove the POLAR RECEIVER JACK (G) from the tape and plug the POLAR RECEIVER into the POLAR RECEIVER JACK. Step 11 Locate the front and back MONOCOLUMN COVERS (#5 &...

  • Page 8: Pre-Operation Checklist

    PRE-OPERATION CHECKLIST Ensure that all fasteners are tight. Make sure the CROSS-TRAINER is properly leveled and stable. (Refer to the Operation Manual). Ensure that the Leveler Jam Nuts are tight. (Refer to the Operation Manual). Read the entire Operation Manual before using the Cross-Trainer. LISTE DES VÉRIFICATIONS À...