LifeFitness CLUB Series Assembly Instructions Manual page 13

FIGURE 11
STEP 11:
• SECURELY assemble the GUIDE ROD SUPPORT (8) to the TOWER (1) using four RH CAPS (28), two 3/8 X 2-1/2" BOLTS
(14), four 3/8" RH WASHERS (22) and two 3/8" LOW HEIGHT LOCK NUTS (19) as shown in FIGURE 11. (NOTE: Be sure
to route cable through the hole of the GUIDE ROD SUPPORT (8) before tightening.)
• Slide GUIDE ROD BUSHINGS (30) into the tubes on the GUIDE ROD SUPPORT (8), slide 1" SHAFT COLLARS (29) under-
neath the GUIDE ROD BUSHINGS (30) and SECURELY tighten the set screws.
• Screw the treaded end of the CABLE half way into the end of the shaft on the HEAD PLATE (12) and tighten jam nut securely.
See FIGURE 11
• Insert the WEIGHT STACK PIN (26) into the WEIGHT STACK as shown in FIGURE 11.
1/2
0
8
1/2 1/2
1 2
19
11
27
1/2
3 4
13
28
1
14 3/8 X 2-1/2"
22
1/2 1/2
5
30
29
TIGHTEN!
1A
6