Related Manuals for LifeFitness INTEGRITY Series
Summary of Contents for LifeFitness INTEGRITY Series
- Page 1 INTEGRITY AND CLUB SERIES TREADMILLS CLST, CST, & 97T ASSEMBLY INSTRUCTIONS M051-00K58-0379 REV G...
- Page 3 21 Wong Chuk Hang Road marketing.benelux@lifefitness.com HONG KONG Operating Hours: 9.00h-17.00h (CET) Telephone: (+852) 2575.6262 Fax: (+852) 2575.6894 Service Email: HongKongEnquiry@lifefitness.com Sales/Marketing Email: * Also check www.lifefitness.com for local representation or distributor/dealer Marketing.HK.Asia@lifefitness.com Operating Hours: 9.00h-17.00h Service Operating Hours: 9.00h-18.00h...
- Page 4 AVERTISSEMENT: Des problèmes de santé peuvent être causés par une utilisation incorrecte ou excessive de l’équipement. LIFEFITNESS recommande FORTEMENT de consulter un médecin pour subir un examen médical complet avant de commencer tout programme d’exercice, et tout particulièrement si l’utilisateur a des antécédents familiaux d’hypertension ou de troubles cardiaques, s’il a plus de 45 ans, s’il fume, s’il a du choles-...
-
Page 5: Table Of Contents
Table of Contents 1. Getting Started ................4 1.1 Important Safety Instructions . -
Page 6: Getting Started
Getting Started IMPORTANT SAFETY INSTRUCTIONS Read all instructions before using the LIFE FITNESS treadmill. ƒ DANGER: To reduce the risk of electrical shock, always unplug Life Fitness products before cleaning or attempting any maintenance activity. ƒ WARNING: To reduce the risk of burns, fire, electric shock, or injury, it is imperative to connect each product to a properly grounded electrical outlet. - Page 7 Never place liquids of any type directly on the unit, except in an accessory tray or holder. Containers with lids ƒ are recommended. ƒ Do not use these products in bare feet. Always wear shoes. Wear shoes with rubber or high-traction soles. Do not use shoes with heels, leather soles, cleats or spikes.
- Page 8 CONSIGNES DE SÉCURITÉ IMPORTANTES Lire toutes les instructions avant d’utiliser le tapis roulant. ƒ DANGER: Pour réduire les risques de décharge électrique, toujours débrancher cet appar- eil Life Fitness avant lenettoyage ou toute mesure d’entretien. ƒ AVERTISSEMENT: Pour réduire les risques de brûlures, d’incendies, de décharges électriques ou de blessures, chaque appareil doit absolument être branché...
- Page 9 Ne jamais rien insérer dans les ouvertures de cet appareil. Si un objet tombe à l’intérieur de l’appareil, couper ƒ l’alimentation électrique, débrancher le cordon de la prise et le récupérer avec précaution. S’il est impossible de l’atteindre, communiquer avec le service à la clientèle de Life Fitness. Ne jamais placer aucun liquide directement sur l’appareil, sauf dans le plateau pour accessoires ou un support ƒ...
-
Page 10: Set-Up
1.2 Set-Up Read the entire manual before setting up the Life Fitness Treadmill. Place the treadmill where it will be used before beginning the setup procedure. Electrical Power Requirements The Life Fitness Treadmill requires a dedicated* line with isolated neutral according to the electrical configurations listed in the chart below (Integrity ONLY). - Page 11 How to Position and Stabilize the Life Fitness Treadmill Follow all safety instructions in Section 1.1 and move the treadmill to the location in which it will be used. See Section 4 for the dimensions of the product footprint (as- sembled dimensions).
- Page 12 Fitness Networking The two interchangeable type RJ45 networking ports (D) are located on the back of the display console. These network ports, located behind the display console rear access door, allow the treadmill to be connected to a fitness entertain- ment system and/or a fitness network such as FitLinxx®.
-
Page 13: Service And Technical Data
Use Gym Wipes on the equipment for at least 2 minutes for general disinfection purposes. Contact Life Fitness Customer Support Services to order these cleaners (800-351-3737 or email: customersupport@ lifefitness.com). Life Fitness Compatible Cleaners Mild soap and water or a mild non-abrasive household cleaner can also be used to clean the display and all exterior surfaces. -
Page 14: Preventive Maintenance Schedule
2.2 Preventive Maintenance Schedule Item Weekly Monthly Quarterly Biannually Annually DISPLAY CONSOLE ASSEMBLY Hardware Clean Inspect Console Overlay Clean Inspect Accessory Cups Clean Inspect Stop Swtich Clean Inspect Emergency Clean / Inspect Switch/Magnet HANDLEBAR ASSEMBLY Hardware Inspect Ergo™ Front Clean Inspect Handlebar Side Hand Rails... -
Page 15: How To Adjust And Tension The Striding Belt
2.3 How to Adjust and Tension the Striding Belt Do not move the treadmill or place hands under the treadmill while it is plugged into an electrical outlet! The Belt Tensioning Bolts A 5/16-inch hex key wrench is required for this task. The Life Fitness Treadmill has access holes in the rear roller guards which allow access to the tensioning bolts. -
Page 16: How To Obtain Product Service
Tensioning an Existing Striding Belt Press GO and operate the treadmill for five minutes at 5.0 MPH (8.0 KPH). Note: DO NOT RUN OR WALK ON BELT. Reduce the speed to 2.0 mph (3.2 kph). Walk on the treadmill. Tightly grip the handrails and apply force with feet on the striding belt near the motor cover against the moving belt direction. -
Page 17: Assembly
Assembly Component List Tools Required: • #2 Phillips screwdriver • 4mm, 5mm, 8mm Allen Head Drivers (T-Bar recommended) Part Description Upright (Left) Upright (right) Handlebar (left and right) Ergo™ front crossbar Left inside handlebar shroud Right inside handlebar shroud Left outside handlebar shroud Right outside handlebar shroud Display console Lower upright cover (left and right... - Page 18 Hardware SCREW GROMMET (#18) HANDLEBAR SHROUD SCREW (#15) FRONT CROSSBAR NUT (#22) ENDCAP / UPRIGHT COVER SCREW (#16) UPRIGHT WASHER (#24) LINECORD CLIP (#23) DISPLAY CONSOLE / HANDLEBAR SUPPORT SCREW (#17) FRONT CROSSBAR SCREW (#19) UPRIGHT MOUNTING BOLT (#20) ACCESSORY TRAY SCREW (#21)
- Page 19 IMPORTANT! DO NOT DISCARD THE SHIP KIT LOCATED ON TOP OF THE DECK AND BELT. ALL NECESSARY COMPONENTS NEEDED TO COM- PLETE THE INSTALLATION ARE LOCATED IN THE SHIP KIT. NE JETEZ PAS LE KIT D’EXPÉDITION PLACÉ SUR LE DESSUS DU PLATEAU ET SUR LE TAPIS. IL CONTIENT TOUS LES ÉLÉMENTS NÉCESSAIRES POUR L’INSTALLATION.
- Page 20 With the bend of one Handlebar (3) directed to the outside of the treadmill, insert the Handlebar into the Right Upright Handlebar Bracket (L) as shown. Be sure the handlebar mounting holes are aligned. Repeat for the left side Handle bar.
- Page 21 Slide the Left Inside Handlebar Shroud (5) near the Left Upright Handlebar Bracket (N). Locate and position the Left Outside Handlebar Shroud (7) to match the Left Inside Handlebar Shroud. Secure the Shrouds together using three Screws (15). Tighten the Screws securely. Do not overtighten the Screws. Repeat the procedure for the Right Inside and Outside Handle bar Shrouds (6 &...
- Page 22 Locate the Left Accessory Tray (11). Carefully slide the tray into the top of the Left Upright (1) as shown until fully seated. Secure the accessory tray to the Left Top Mounting Plate (H) using four Screws (21). Repeat the proce dure for the Right Accessory Tray (12) and Right Top Mount ing Plate (J).
-
Page 23: Specifications
Specifications 4.1 Life Fitness CLST Treadmill specifications Designed use: Heavy / Commercial Maximum user weight: 400 pounds / 181 kilograms Speed range: 0.3 - 14.0 mph (0.5 - 23 kph) in 0.1 increments Elevation range: 0%-15% (in 0.1% increments) Drive train: AC motor with MagnaDrive™...