LifeFitness CLUB Series Assembly Instructions Manual page 9

TIGHTEN SCREWS (BOTH SIDES)
25
1A
18 3/8 X 3"
BUTTON
HEAD
7A
1
22
28
21
19
2
7
FIGURE 6
STEP 6:
• SECURELY assemble the PILLOW BLOCKS (25) on the PIVOT ARM (7) to the TOWER (1) and the PIVOT ARM SUPPORT
(2) using four previosly inserted 3/8 X 3" BUTTON HEAD CAP SCREWS (18), four 3/8" SAE WASHERS (21), four RH
WASHERS (22), four 3/8" LOW HEIGHT LOCK NUTS (19) and four RH CAPS (28) as shown in FIGURE 6
• IMPORTANT! When PIVOT ARM (7) is centered and level in the PILLOW BLOCKS (25), tighten the PILLOW BLOCK set
screws.
9