Table of Contents
Advertisement
6 6
Measurement
This section describes the operations using the mouse. If the touch panel display is connected, read the following
operations as those on the right side.
• "Click with mouse" (Left button)
• "Double-click with mouse" (Left button)
• "Right-click with mouse" (Right button)
• "Drag with mouse" (Left button)
66
"Tap with finger" (Touch with finger and release)
"Double-tap with finger" (Touch with finger twice and release)
"Hold with finger" (Long-press with finger)
"Swipe with finger" (Slide finger while touching)
1
Measurement functions
You can measure the distance or the area of the object on the image.
There are two measurement methods: measurement method on the
live image and the measurement method on the played image.
Before measurement, the scale must be set in advance.
NOTE
When measuring on the played image, if the scale display
is not set (setting of acquisition magnifications, etc.), the
measurement data is not displayed correctly.
For setting procedures, see "Setting the microscope
(p.84)".
· When you measure on the live image, the frame rate may be
TIP
reduced.
· The played images listed below cannot be measured.
·
Movie
·
Image edited by PC
·
Image acquired by a camera other than DP23-CU or
DP28-CU.
· When using the measurement function, it is recommended to
set the same resolution to the live image and the image to be
acquired.
If the resolution of the live image is different from that of the
image to be acquired, the position to display the measurement
results of the live image may shift from that of the acquired
image.
· To input texts, the keyboard must be connected to DP2-AOU.
· This measurement function is a simple measurement method
using CMOS pixel pitch. This is not suitable for the precise
measurement. Use the measuring equipment for the precision
measurement.
· The measurement results are displayed with 4 effective digits
for distance, 5 digits for angle and 7 digits for area respectively.
Note, the unit of measurement results cannot be changed.
· The measurement results are displayed near the lines or
circles drawn. The display position or display digits cannot be
changed.
Advertisement
Table of Contents
