Table of Contents
Advertisement
5-12. Touch Screen
The QT-8000 is equipped with a quick-response touch screen that enables keyboard-less
operation. To use the touch screen, a related application program needs to be installed.
This chapter provides all of the information to install and use the software of the Liyitec
touch screen systems for Windows XP.
5-12-1. System Requirements
The Liyitec touch screen system requires a USB interface. USB5 is assigned for the touch
screen system in the QT-8000 system.
5-12-2. Installation
This section describes the installation procedure for the Windows Driver Disk.
There are two steps to install the touch screen drivers into the QT-8000 system.
Step 1: Driver installation
Step 2: Calibration
5-12-2-1. Driver installation
The accompanying Windows Driver Disk contains the following software:
• For Windows XP
1) Run the "setup.exe" (Touch Panel Windows XP Driver disk) file.
2) Select "next".
3) Click "OK" button.
4) Port setting window should open. Default condition is as below.
Mice and other pointing device, USB Touch controller
In the case that you want to use the touch panel as it is, click "OK" button.
5) Restart the system
- 45 -
Advertisement
Table of Contents
