Spark Plug - Segway FUGLEMAN SGW1000F-U2 Owner's Manual

1. Remove the CVT drain plug.
2. Wait for the water to drain and reinstall the drain plug.
2. Start the engine.
3. Increase the engine speed and maintain it for 10-15 seconds
to remove the excess moisture and to dry the belt and CVT.
DO NOT fully open the throttle during this operation.
4. Shift gears to the low range and test for belt slippage.
5. If the belt still slips, repeat the process.
6. Visit your Segway Powersports dealer if your vehicle needs
service.

SPARK PLUG

Refer to the specifications below for the recommended spark plug
type and gap.
0.7- 0. 9 mm
MAINTENANCE AND STORAGE
Using other than recommended spark
plug can cause serious engine damage.
Always use the recommended spark
plugs or their equivalents.
Type
Spark plug gap
Tightening torque
115
!
CAUTION
Spark Plug
NGK CPR7EA
0.7-0.9 mm
11 Nm