Segway FUGLEMAN SGW1000F-U2 Owner's Manual page 100

O P E R A T I O
O P E R A T I O
• When using the winch to move the load, place the vehicles
transmission in neutral and apply the brake of the vehicle
and place wedges under each wheel. When the hoist is
working, the vehicle engine should be operated to charge the
battery. Never use the winch with insufficient voltage.
• Never disconnect the power supply when there is a load on
the winch.
• After the operation, release the load immediately and do not
tighten the rope.
• Always stay away from ropes, hooks and winches when in
operation or under load.
• Check winches, ropes, hooks, and broken strands of worn
rope regularly. When handling the rope, wear thick leather
gloves. Do not let the rope slip over your hands. Check
the rope before use.
• Crushed, pinched, worn or kinked areas seriously reduce the
carrying capacity of the rope. Damaged rope should be
replaced. It must be re-wound under a load of about 50 kg.
• The clutch should be disconnected first, and then the rope
should be pulled by the hook of the protective lever. Do not
pull the rope directly through the hook with your fingers.
• Maintain the specified tension so that the rope can be wound
on the drum and re-rolled after the operation tight.
• Do not operate the winch if you are under the influence of
alcohol or drugs. Be cautious during operation. If there is a
problem, you should cut off the power immediately and
check the battery.
• Wear goggles, long sleeves, non-slip boots, work caps, thick
leather gloves. Place long hair tightly under a work cap and
remove all personal jewelry.
N
N
88