TP-Link TL-WR802N User Manual page 75

Chapter 5
•
• Authentication Type
Note:
Sometimes the connection cannot be terminated although you have specified the
applications are visiting the internet continually in the background.
• Service Name/Server Name
configured unless you are sure it is necessary for your ISP. In most cases, leaving
these fields blank will work.
• MTU(Bytes)
change the default MTU size unless required by your ISP.
• Enable IGMP Proxy
multicasting on TCP/IP networks. Some ISPs use IGMP to perform remote configuration
for client devices, such as the modem router. The default value is enabled, and if you
are not sure, please contact your ISP or just leave it.
• ISP Specified IP Address
the router, please select
provided by your ISP in dotted-decimal notation.
• Echo Request Interval
interval. The default value is 0. You can input the value between 0 and 120. The value
0 means no detect.
• DNS Server/Secondary DNS Server
addresses to the router, please select
address in dotted-decimal notation of your ISP's primary DNS server. If a secondary
DNS server address is available, enter it as well.
Downloaded from ManualsNet.com
field. Otherwise, enter the number of minutes you want to have elapsed before
your internet access disconnects.
Connect Manually - You can click
immediately. This mode also supports the
on Demand mode. The internet connection can be disconnected automatically
after a specified inactivity period (Max Idle Time) and not be able to re-establish
when you attempt to access the internet again.
- Choose an authentication type.
- The default MTU size is 1480 bytes. It is not recommended that you
- IGMP (Internet Group Management Protocol) is used to manage
- If your ISP does not automatically assign IP addresses to
Use IP address specified by ISP
- The router will detect Access Concentrator online at every
search engine
Configure the Router in WISP Mode (Hotspot Mode)
Connect/Disconnect
Max Idle Time
- The service name and server name should not be
- If your ISP does not automatically assign DNS
Set DNS server manually
to connect/disconnect
function as Connect
Max Idle Time because some
and enter the IP address
and enter the IP
71