TP-Link TL-WR802N User Manual page 122

Chapter 5
Download and install the certificate for management via HTTPS if you need it. Once the
certificate is installed, warnings will not pop up when you access the router via HTTPS.
Note:
• To access the router, enter your router's WAN IP address in your browser's address bar, followed by a colon and
the custom port number. For example, if your router's WAN address is 202.96.12.8, and the port number used is
8080, please enter http://202.96.12.8:8080 in your browser. Later, you may be asked for the router's password. After
successfully entering the username and password, you will be able to access the router's web management page.
• Be sure to change the router's default password for security purposes.
5. 16. 10. System Log
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to
• Loge Type
• Log Level
• Refresh
• Clear Log
page.
5. 16. 11. Statistics
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to
3. Select
including total traffic and the value of the last Packets Statistic interval in seconds.
Downloaded from ManualsNet.com
System Tools > System
-By selecting the log type, only logs of this type will be shown.
- By selecting the log level, only logs of this level will be shown.
- Refresh the page to show the latest log list.
- All the logs will be deleted from the router permanently, not just from the
System Tools > Traffic Statistics.
Enable and click Save. You can view the network traffic of each PC on the LAN,
search engine
Configure the Router in WISP Mode (Hotspot Mode)
Log, and you can view the logs of the router.
118