TP-Link TL-WR802N User Manual page 66

Chapter 4
• Allow a specific device to manage the router locally
1. Enter the IP or MAC address of the host that you want to manage the router in the
Available Host (IP/MAC)
(X is any hexadecimal digit).
2. If you want to access the router via both HTTPS and HTTP, please tick the
in HTTPS Service
3. Keep the Port as default if you don't know which port to use.
4. Click Save.
Note:
If your PC is blocked but you want to access the router again, press and hold the
factory defaults.
• Certificate
Download and install the certificate for management via HTTPS if you need it. Once the
certificate is installed, warnings will not pop up when you access the router via HTTPS.
4. 16. 9. Remote Management
This feature allows you to manage your router from a remote location via the internet.
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to
• Forbid all devices to manage the router remotely
Do not tick the
• Allow all devices to manage the router remotely
1. Tick the
2. If you want to access the router via both HTTPS and HTTP, please tick the
checkbox in
3. For higher security, you can change the remote management web port by entering a
number between 1024 and 65534.
4. Click Save.
Downloaded from ManualsNet.com
entry. The format of the MAC address is XX:XX:XX:XX:XX:XX
column. Otherwise, keep it disbled.
System Tools > Administrator, and focus on the
Enable checkbox in both
Enable checkbox in HTTP
HTTPS Service column. Otherwise, keep it disbled.
search engine
Configure the Router in Wireless Router Mode
Reset
Service Configuration
HTTP Service and HTTPS
Service.
Enable box
button to reset the router to the
section.
Service.
Enable
62