Sherwood Newcastle R-871 Operating Instructions Manual page 55

When selecting the DC TRIGGER
• To turn on the component connected to the DC TRIGGER OUT jack when this input source is selected,
you should set the DC TRIGGER to ON for this input source.
OFF : To turn off the DC trigger function.
ON: To turn it on.
• For details, refer to "CONNECTING DC TRIGGER OUT" on page 9.
When selecting the NAME
• You can give names to the input sources other than tuner.
• Up to 7 characters can be entered for each name.
Press the CURSOR UP(▲)/DOWN(▼) buttons to select the desired input source, then
1
press the ENTER button.
Press the CURSOR UP(▲)/DOWN(▼) buttons to select the NAME, then press the ENTER button.
2
Press the CURSOR LEFT(◀)/ RIGHT(▶)
3
buttons to select the desired digit.
• Then the selected digit will flicker.
5
Repeat the above steps ③ and ④ to enter the desired characters on the rest of the digits.
Confirm your entry.
6
Example: When selecting the VIDEO 1
• The first digit flickers.
Press the CURSOR UP(▲)/DOWN(▼)
4
buttons to enter the desired character on
the flickering digit.
• You can enter the desired among blank, A ~ Z,
a ~ z, 0 ~ 9, (, ), , +, , , -, ., /.
• The name is stored in the memory.
■To resume its factory input source name.
• Make a blank on each digit and press the ENTER
button.
54