Sherwood Newcastle R-871 Operating Instructions Manual page 31

When CD, AUX, VIDEO 1~ 5 is selected as an input source
Select the digital or the analog input connected as desired.
4
■Notes:
• When TUNER, TAPE or EXTERNAL IN is selected as an input source, the digital input cannot be selected.
• When the selected digital input is not connected, the "DIG." indicator flickers and the analog input is
automatically selected.
• The selected digital or analog input is automatically assigned to the corresponding input source on the
INPUT SETUP menu. (For details, refer to "SETTING THE INPUT SETUP" on page 52.)
• The sound from the component connected to the selected digital input can be heard regardless of the
selected input source.
Operate the selected component for
5
playback.
• When playing back the program sources with
surround sound, refer to "ENJOYING
SURROUND SOUND" on page 34.
Muting the sound
• "MUTE" flickers.
• To resume the previous sound level, press it again.
• Each time this button is pressed, the
corresponding input is selected as follows:
Adjust the (overall) volume.
6
Listening with headphones
• Ensure that the SPEAKER button is set to off.
• Depending on the signal format which is being
input, you can listen in different Dolby
Headphone modes, stereo mode, etc. (For
details, refer to "Listening in a Dolby Headphone
mode" on page 35).
• When the EXTERNAL IN is selected as an input
source, only front left and front right channel
signals can be reproduced through the
headphones.
30