Sherwood Newcastle R-871 Operating Instructions Manual page 28

Erasing all the punch-through functions
programmed under a master device mode
Perform the steps ③ and ④ in
1
"Entering a setup code" procedure on
page 20 to select a master device and
the punch-through mode ("PUNCH").
• Then "VOL" is displayed on the LCD screen for
several seconds.
While "DELETE" is displayed, to erase
3
all the punch-through functions
programmed under the master device
mode, press ENTER button.
• Then "OK" is displayed and "DELETE" is
displayed.
• To exit from the deleting mode, press any of the
DEVICE buttons.
While "VOL" is displayed, press the
2
CURSOR UP(▲)/DOWN(▼) buttons to
select the all punch-through deleting
mode ("DELETE").
• Each time the CURSOR UP(▲)/DOWN(▼)
buttons are pressed, the mode changes as
follows:
→ VOL DELETE
• Then "DELETE" is displayed .
To erase all the punch-through
4
functions programmed under other
master device mode , repeat the above
steps ① to ③.
27
PLAY CH ←