Sherwood Newcastle R-871 Operating Instructions Manual page 26

Programming a punch-through function
• The punch-through function allows the volume
controls, channel controls or transport controls
to link to a different device while a device is
controlled with this remote control as a master
device.
• For example, since this receiver will likely be
used as the sound system while watching TV,
you may want to use volume controls to operate
this receiver although this remote control is set
to control the TV.
Perform the steps ③ and ④ in
1
"Entering a setup code" procedure on
page 20 to select a master device and
the punch -through mode ("PUNCH").
• Then "VOL" is displayed on the LCD screen for
several seconds.
While the device is displayed, press the
3
CURSOR UP(▲)/DOWN(▼) buttons to
select the desired punch-through
device, then press the ENTER button.
• Each time the CURSOR UP(▲)/DOWN(▼)
buttons are pressed, depending on the selected
punch-through mode, punch-through devices
and the one punch-through deleting mode
("DELETE") are selected as follows :
• In case of the volume punch-through,
AUDIO DELETE TV
→
• In case of the transport punch-through,
→ CD DELETE DVD
• In case of the channel punch-through,
→ TV DELETE SAT
• Then "OK" is displayed and the current punch-
through mode is displayed.
• Each time the CURSOR UP(▲)/DOWN(▼)
buttons are pressed, the mode changes as
follows:
→
→
• Then the device to which you can link the
selected punch-through mode is displayed.
←
VCR AUX ←
CABLE VCR ←
25
While "VOL" is displayed, press the
2
CURSOR UP(▲)/DOWN(▼) buttons to
select the desired punch-through mode
, then press the ENTER button.
VOL : The volume punch -through mode
allows the "VOLUME
"MUTE" buttons to operate a different
device.
DELETE : All punch-through deleting
mode.
PLAY : The transport punch-through mode
allows the " ◀ ◀ ", " ● ", "
" ▶ ▶ ", " ◀/ " and " ▶ " buttons to
operate a different device.
CH : The channel punch-through mode
allows the "CHANNEL
LEVEL" buttons to operate a different
device.
While the punch-through mode is
4
displayed, repeat the above steps ②
and ③ to program other punch-through
function under the same master device
mode.
To program punch-through functions
5
under other master device mode,
repeat the above steps ① to ④.
▲ / ▼ " and
▶ ▶ ", " ◀ ◀ ", " ",
∧ / ∨ " and "CH.