Sherwood Newcastle R-871 Operating Instructions Manual page 22

Operate the component using the corresponding function buttons.
6
• If any of buttons fails to operate as they should , start from the step
Notes:
• Manufacturers may use different setup codes for the same product category. For that reason, it is important
that you check to see if the code you have entered operates as many controls as possible. If only a few
functions operate, check to see if another code will work with more buttons.
• When operating a Sherwood CD player or tape deck using the system remote control, aim the remote control
at the REMOTE SENSOR on this receiver.
However, in case of Sherwood DVD player and MD recorder, aim it at the REMOTE SENSOR on the
corresponding component.
Repeat the above steps ① to ⑥ for each of your other components.
7
Searching a setup code
• In addition to enter a setup code using "Setup
Code Table" on page 71, it is also possible to
search through all the codes that are stored in
the library of this remote control.
Turn on the component you want to
1
operate.
While "PRESET" is displayed, search a
3
setup code, aiming the remote control
at the remote sensor on the
component.
• Each time the CURSOR UP(▲)/DOWN(▼)
buttons are pressed, the setup code is selected
one by one.
• If the selected code is correct, your component
will be turned off.
• When your component is not turned off, repeat
this step until you find one that works.
Operate the component using the
5
corresponding function buttons.
• If any of buttons fails to operate as they
should, start from the step ① again to find the
correct setup code.
① again to enter the correct setup code.
Perform the steps ③ and ④ in
2
"Entering a setup code" procedure on
page 20 to select the setup code mode
("CODE").
While "PRESET" is displayed, press the
4
ENTER button to store the setup code.
• Then "OK" is displayed on the LCD screen.
Repeat the above steps ① to ⑤ for
6
each of your other components.
21