Sherwood Newcastle R-871 Operating Instructions Manual page 23

Programing the commands from other
remote controls (LEARNING mode)
• If the setup codes are not available for your
component or you want to program a missing or
special function into one button of a device, the
learning function enables this remote control to
learn the commands from other remote controls.
Place this remote control and other
1
remote control facing each other at a
distance of 5 to 15 cm (2 to 6 inches )
apart.
While "LEARN" is displayed, press the
3
ENTER button.
• Then "SEL" is flickering.
• If "SEL" goes off, start again from the above
step ②.
While "READY" is displayed, on the
5
other remote control, press the button
of the function to be learned.
• If the command has been learned successfully,
"OK" is displayed and then "SEL" is flickering.
• If "ERROR" is displayed and then "SEL" is
flickering, it means that for some reason the
command was not learned. In this case, repeat
the above steps ④ and ⑤.
Notes :
• If an incorrect signal has been sent or, in some
cases, the command from other remote control
simply cannot be learned.
• In some "ERROR" cases, the remote controls
just need to be moved closer together or
farther apart.
Press and hold down the ENTER
2
button and the desired one of the
DEVICE buttons for more than 2
seconds.
• Then "LEARN" is displayed on the LCD screen
for several seconds
Note :
• During setting operation, to exit from the setting
mode, press any of the DIVICE buttons.
While "SEL" is flickering, on this remote
4
control, press the button corresponding
to the function to be learned.
Example: If the function to be learned is playback,
press the PLAY(▶) button.
• Then "READY" is displayed.
Note:
• You cannot program a function into some
buttons such as DEVICE, MACRO and LIGHT
buttons.
While "SEL" is flickering, repeat the
6
above steps ④ and ⑤ to program all
the commands you want to the buttons
on this remote control under the same
device mode.
To exit from the setting mode, press any of the
DEVICE buttons.
Repeat the above steps ① to ⑥ to
7
program the commands from a different
remote control.
Operate the newly programmed buttons
8
to make sure the learning function was
performed properly.
22