Setting The Length Of Alarm Beeps - Sharp AL-1661CS Operation Manual

SETTING THE LENGTH OF ALARM BEEPS

You can select the length in seconds of the alarm beeps (emitted at the end of transmission and reception) following
the procedure below.
1
Press the [MENU] key.
2
Press the [ ] key (
until "4:USER PROGRAM" appears,
and then press the [ENTER] key.
Selection
"4:USER PROGRAM"
3
Press the [ ] key (
until "17:BEEP LENGTH" appears,
and then press the [ENTER] key.
Selection
"17:BEEP LENGTH"
4
Press the [ ] key (
to set the alarm beeps to the desired
length or to turn them off.
5
Press the [ENTER] key.
18
) or [ ] key ( )
) or [ ] key ( )
) or [ ] key ( )
The selections are as
follows:
1:3SEC
2:1SEC
3:NO BEEP
6
Press the [CLEAR ALL] key ( ).
Press the [CLEAR ALL]
key ( ) to exit.