Swivelling The Roll-Over Safety Bar Upward And Downward And Locking It - Kubota K008-3 Operating Instructions Manual

Operation

Using the dozer control lever (1), adjust the desired track
width.

To decrease the track width from 990 to 750 mm, move the
dozer control lever forward (figure position ).

To increase the track width from 750 to 990 mm, move the
dozer control lever backward (figure position ).

After adjusting the track width, immediately move the selec-
tor lever for the dozer/track width fully to the left (figure
above, position ).
Do not operate the excavator with the narrow track
width (750 mm), risk of flipping. Always use the
standard track width (990 mm) unless you pass
through narrow places on a flat surface.
Changing the standard dozer blade width to narrow:

Pull out the lock pin (1) and remove the dozer extension (2).

Attach the dozer extension as shown in the figure, fit in the
lock pin.

Use the same procedure for the other side (left or right) as
well as for the adjustment of the track width from narrow to
standard.

Swivelling the roll-over safety bar upward and downward and locking it


Position the front attachments as illustrated.

Turn off the engine (page 63).
W9212-8235-4
03/2019
67