Replacing The Fuel Filter; Draining Water From The Fuel Tank - Kubota K008-3 Operating Instructions Manual

Maintenance

Replacing the fuel filter


Open the engine hood (page 89).

Set the cock (1) horizontal to the "C" position.
Place a cleaning cloth under the fuel filter to pre-
vent fuel from spilling on the ground.

Remove the filter cup retainer (4) while holding the filter cup
(3).

Remove the filter cup and filter.

Clean the filter cup with clean diesel fuel.

Replace the fuel filter (2) and the sealing rings (1).

Apply a light coat of diesel fuel onto the sealing rings.

Assemble the components in the order shown in the figure above. Tighten the filter cup retainer (4) by
hand. Do not use a tool.

Set the cock vertical to the "O" position.

Bleed the fuel system (page 87). Check the water separator for leaks at the same time.

Close the engine hood.

Draining water from the fuel tank


Place a container with a minimum capacity of 20 L under
the fuel drain plug.

Remove the drain plug (1) and drain the water.

Install the drain plug with a new o-ring on it.
W9212-8235-4
03/2019
105