Operating The Controls During Excavation Work - Kubota K008-3 Operating Instructions Manual

Operating the controls during excavation work

Always observe the following safety instructions when working with the excavator.

The maximum track width (standard track width) should also be set before excavation work in order to
ensure maximum stability while working with the machine.

The suitability of the machine for attachments depends on the size, weight and arm attachment (interface).
These factors should be observed by the operator. Various attachments (e.g. light cargo buckets) can only
be used on a restricted basis.

Using a light cargo bucket can, depending on the nature of the bulk material, exceed the tipping load of the
machine.

Breaking concrete or rocks with the bucket is prohibited.

Do not use the dropping action of the bucket for excavation.

Never fully extend the cylinders. Always keep a certain safety margin, especially when operating with a
breaker (accessory).

Never use the bucket as a hammer to drive posts into the ground.

Do not drive or dig with the bucket teeth rammed into the ground.

When loading soil, do not dig the bucket deeply into the ground. Instead, make relatively shallow slices
with the bucket out as far as possible. This technique reduces the stress on the bucket.

When working in water, the water should only reach up the lower edge of the swivel frame.

After using the machine in water, always grease the pins at the bucket and arm with grease until the old
lubricating grease emerges.

When digging with the boom above the dozer, make sure that the boom cylinder does not come into con-
tact with the dozer.

It is not allowed to use the excavator for crane work.

Adhering soil can be shaken off when the bucket is being emptied by moving the cylinder to the end of the
stroke. Should this not suffice, swing out the arm as far as possible and operate the bucket back and forth.
72
Operation
W9212-8235-4
03/2019