Recovery, Loading And Transport; Safety Rules For Recovery; Safety Rules For Hoisting The Excavator With A Crane; Safety Rules For Transport - Kubota K008-3 Operating Instructions Manual

RECOVERY, LOADING AND TRANSPORT

Safety rules for recovery


For recovery of the excavator, a towing vehicle of at least the same weight class as the excavator must be
used.

A tow bar must be used for the recovery. If a tow rope is used, an additional vehicle to brake the excavator
must also be attached. The tow bar or tow rope must be suitable for the recovery of the excavator in re-
spect of the towed load. Do not use damaged recovery aids.

Do not step into the danger zone between the vehicles during the recovery procedure. If a tow rope is
used, keep a distance of at least 1½ times the length of the rope.

Use the towing eye on the track frame for the recovery.

The above safety rules also apply if the excavator is used as the towing or recovery vehicle.

Observe the admissible values for the towed load and the maximum pressing load vertical down on the
towing eye during recovery, see "Specifications" (page 36).

Safety rules for hoisting the excavator with a crane


The lifting gear for hoisting must be suitable for the weight of the excavator.

Before the lifting gear is attached, check that the specified safety inspections have been performed and the
lifting gear is in perfect condition.

The excavator may only be lifted at the points provided. Do not attach the lifting gear to any other grom-
mets or areas as this can lead to substantial damage.

Always adhere to the valid safety regulations for the lifting of loads.

The excavator must be secured with a holding rope when it is being lifted.

The crane operator is responsible for the observance of these safety rules.

Safety rules for transport


The ramps must have a sufficient load capacity for bearing the weight of the excavator. They must be
placed securely on the transport vehicle and fastened.

Support the loading area at the rear of the transport vehicle with sufficiently dimensioned supports.

The ramps must be wider than the track of the excavator and have footboards on the side.

The transport vehicle must be designed for the load of the excavator.

Place the left and the right ramp so that the centre line of the transport vehicle is aligned with the centre
line of the excavator to be loaded.

Do not drive the excavator onto the transport vehicle without ramps and with the boom.

Engage the parking brake of the transport vehicle and secure its front and rear wheels with chocks.
28
Recovery, loading and transport
W9212-8235-4
03/2019