Checking The Coolant Level; Checking The Radiator; Checking The V-Belt - Kubota K008-3 Operating Instructions Manual

Checking the coolant level


Check the coolant level in the expansion reservoir (1). The
fluid level must be between FULL and LOW.
Do not open the radiator cap.
If the coolant level is below the LOW mark, refill
(page 99).
If the coolant level is below the LOW mark a short time after adding coolant, the cooling system
is leaky. The excavator must only be started again after the fault is repaired.

Checking the radiator


Check the radiator (1) for leaks and debris (e.g. leaves).

If there are leaves or other debris at the radiator, clean the
radiator (page 100).

Checking the V-belt


Check the V-belt (1) for cracks and proper tension. It should
be possible to depress the V-belt for about 10 mm. Tighten
the V-belt (page 100).
56
Operation
W9212-8235-4
03/2019