Replacing The Fuel Filter - Kubota K008-5 Operating Instructions Manual

The internal filter element must only be replaced by skilled personnel in the framework of the corresponding ser-
vice period.
Do not clean the filter element with fluids. Never operate the engine without the air filter elements.
STOP
Always wear eye protection when working with compressed air.
STOP
Clean the outer filter element with compressed air (max. 5 bar)

from the inside out without damaging the filter element. Wear
eye protection for this service.
Insert an outer filter element.

Install the cover with the TOP mark so that the mark is turned

5° (K008-5) or 35° (U10-5) to the left.
Then lock the braces.

Close the engine compartment cover and secure it with a pad-

lock.

Replacing the fuel filter

Open the engine hood (page 112).

Set the cock (1) horizontal to the "C" position.

Place a cleaning cloth under the fuel filter to prevent
fuel from spilling on the ground.
Remove the filter cup retainer (4) while holding the filter cup (3).

Remove the filter cup and filter.

Clean the filter cup with clean diesel fuel.

Replace the fuel filter (2) and the sealing rings (1).

Apply a light coat of diesel fuel onto the sealing rings.

Assemble the components in the order shown in the figure

above. Tighten the filter cup retainer (4) by hand. Do not use a
tool.
Set the cock vertical to the "O" position.

Bleed the fuel system (page 109). Check the water separator

for leaks at the same time.
Close the engine hood and secure it with a padlock.

138
Maintenance
1
W9215-8135-1
06/2021