Speed Control - If Equipped; To Activate; To Set A Desired Speed; To Vary The Speed Setting - RAM Commercial PROMASTER Cargo Van 2019 User Manual

as a problem. Please check your oil level with
the engine oil indicator often during the
break in period. Add oil as required.
SPEED CONTROL — IF EQUIPPED
When engaged, the Speed Control takes over
accelerator operations at speeds greater than
25 mph (40 km/h) up to the maximum speed
of 100 mph (160 km/h).
The Speed Control Lever is located on the left
side of the steering column.
Speed Control Lever
1 — Resume
2 — Set/Accel
3 — On/Off
4 — Decel
NOTE:
In order to ensure proper operation, the
Speed Control System has been designed to
shut down if multiple Speed Control func-
tions are operated at the same time. If this
occurs, the Speed Control System can be
reactivated by rotating the Speed Control
ON/OFF center ring and resetting the desired
vehicle set speed.

To Activate

Rotate the center ring upward on the Speed
Control lever to turn the system on. The
Cruise Indicator Light in the instrument clus-
ter display will illuminate. To turn the system
off, rotate the center ring upward a second
time. The Cruise Indicator Light will turn off.
The system should be turned off when not in
use.
WARNING!
Leaving the Speed Control system on when
not in use is dangerous. You could acci-
dentally set the system or cause it to go
faster than you want. You could lose con-
WARNING!
trol and have an accident. Always leave the
system off when you are not using it.

To Set A Desired Speed

Turn the Speed Control on. When the vehicle
has reached the desired speed, move the
Speed Control lever upward SET (+) and
release. Release the accelerator and the ve-
hicle will operate at the selected speed.
NOTE:
The vehicle should be traveling at a steady
speed and on level ground before moving the
Speed Control lever upward SET (+).

To Vary The Speed Setting

To Increase Speed
When the Speed Control is set, you can in-
crease speed by tapping the Speed Control
lever up SET (+).
The driver's preferred units can be selected
through the radio settings if equipped. Refer
to "Uconnect Settings" in "Multimedia" in
71