Installation; Unpacking; Getting Started; Opening The Enclosure - Rice Lake MSI-8000HD Technical Manual

Rf remote display
Hide thumbs Also See for MSI-8000HD:
Table of Contents

Advertisement

MSI-8000HD RF Remote Display
2.0

Installation

This section provides an overview of MSI-8000HD RF Remote Display installation instructions.
2.1

Unpacking

When unpacking the MSI-8000HD, ensure that all parts are accounted for and check for any visible damage. If any parts were
damaged in shipment, notify Rice Lake Weighing Systems and the shipper immediately. If the MSI-8000HD must be returned, it
must be properly packed with sufficient packing materials. If possible, retain the original carton when shipping the unit back.
2.2

Getting Started

The MSI-8000HD is often shipped pre-configured with a compatible sensor unit such as an Dyna-Link 2 or one of the MSI crane
scales. If the MSI-8000HD is purchased separately, or is to be used with a different system, the RF transceivers will have to be
paired. Follow the RF Setup Procedure in
Once the RF setup is complete for the MSI-8000HD, the system will automatically connect with a scale/Dyna-Link. It is
recommended to do a site survey to identify operating range and usability of the RF Link. Position the scale/Dyna-Link at an
average operational height, and try the link at various positions and distances. The range may vary by the rotation of the scale/
Dyna-Link, as well as the site and installation variables.
Battery Charging (Optional)
For units with an optional battery, fully charge the battery by plugging the charger into the charge port. Depending on the
discharge level of the battery this can take up to six hours.
2.3

Opening the Enclosure

The indicator enclosure must be opened to connect the scale load cell cable and other interface connections.
WARNING: Before opening the unit, ensure the power cord is disconnected from the power outlet.
1. Disconnect the power to the indicator.
2. Place the indicator face down on an anti-static work mat.
3. Remove the screws that secure the backplate to the enclosure.
4. Lift the backplate away to access the boards and set it aside.
4
Visit our website
Section 6.4 on page
Figure 2-1. Battery Charger
www.ricelake.com
28.

Advertisement

Table of Contents
loading

Table of Contents